Tri-Stone Sharpening Benchstone, Lansky

Tri-Stone Bench Stone 2" x 6" Lansky

Lansky delivers the most versatile 3 Stone Shar pener available, Combining 3 of our best stones: Diamond, Alumina-Oxide, and Ceramic. The result is a stand-alone, high-value sharpening center that will do it all, with better versatility than other similar products and last longer doing it. All sharpening surfaces measure 2" x 6".

The continuous diamond surface (120 Grit) will repair and re-profile extremely dull or damaged blades. This is not to be used every time, only on blades in need of serious repair or re-profiling.

The long lasting Alumina-Oxide surface (280 Grit) is where most your touch-ups will occur, before polishing it off with the ceramic side. This is most comparable to a traditional sharpening stone, producing a working-edge that is adequate for most cutting tasks.

The Ceramic surface (1000 Grit) is used for sharpening and finishing. This is what will turn a micro-serrated edge into a smooth, shaving-sharp, cutting edge. The type of edge you can confidently brag about. 

The sturdy plastic base boasts a wide footprint with low-profile and non-slip rubber feet giving the Lansky Tri-Stone Benchstone greater stability, resulting in greater user satisfaction. 

Key features

• diamond stone (100% coverage) for fast reconditioning - 120 coarse Grit
• alumina-oxide stone for sharpening - 280 medium Grit
• ceramic stone for final polishing - 1000 fine Grit
• screw holes included in base for easy bench mounting
• non-slip rubber feet

Instructions

• Step 1- Select the proper stone for your edge.

1. Coarse Diamond Stone- For re-profiling a completely dull or damaged edge
2. Medium Alumina Oxide Stone- To maintain an undamaged, slightly dull edge
3. Fine Ceramic Stone- To hone/polish a finished edge

• Step 2- Set the Tri-Stone Benchstone base on a stable, flat surface with the stone you have selected facing up.

Note: Lubrication of any kind is not recommended while sharpening on any of the three stones. DO NOT USE HONING OIL ON THE DIAMOND STONE.

• Step 3- Observe the bevel angle on the blade you intend to sharpen.  Then, bring the edge to the stone matching your sharpening angle to the bevel angle.
• Step 4- Using light pressure, push the edge of the blade across the stone in one motion, much like trying to slice a thin layer off the top of the stone. Maintaining a consistent angle is essential for the best results.
• Step 5- Repeat process 3-4 times on one side of the blade then switch to the other side and repeat.
• Step 6- Repeat this process until edge is sharp then progress to finer stones and repeat.
• Step 7- Clean your stones.

1. Clean the Diamond stone with a damp rag after each use.
2. Clean your Alumina Oxide stone with Nathan’s Honing Oil® after each use
3. Clean the Ceramic stone with the Lansky Eraser Block® after each use.

Suggestions

1. Use a series of stones for the best results. For an undamaged edge start with the Medium Alumina-Oxide stone.
2. Start with your selected stone. Use 3-4 strokes on one side of the blade. Repeat process on the other side of the blade. Repeat this whole process, switching between sides, about 3-4 times. 
3. Then use only 2 strokes per side.  Repeat this process 2-3 times. 
4. Then 1 stroke per side.  Repeat this process 1-2 times.
5. Move on to a finer stone.

Be Smart, Be Safe and Stay an Edge Above the Rest!

CAUTION: Knife sharpening is an inherently dangerous activity. Used properly this sharpener cannot hurt you but a carelessly handled blade or pointed object can.