Cleaning product "Regular" for silencers, SchleTek

SchleTek Suppressor Cleaner Regular

SchleTek Suppressor Cleaner Regular is a self-active, nonintrusive, yet highly effective cleaner that has been developed specifically for cleaning weapon silencers, both compact and modular models. This special cleaning product by the German specialist SchleTek offers a unique formula that does not damage any surfaces, is pH neutral and fully water soluble.

The SchleTek Suppressor Cleaner Regular is suitable for cleaning all materials and surfaces, even silencers with special finishes such as the Cerakote finish that can be found for example on silencers by the Finnish specialist Ase Utra. SchleTek Regular will remove even heavily resistant residues from your silencer and it will do it quickly, reliably and effortlessly.

SchleTek Suppressor Cleaner Regular is, for example, highly effective even on silencers that are usually very difficult to clean - models that cannot be disassembled, have very fine baffle dividers or hard-to-reach holes. In addition, SchleTek Regular silencer cleaner is also suitable for ultrasonic baths.

INSTRUCTION for use:

The cleaning process varies slightly depending on what type of silencer you plan to clean with it - compact silencer or a silencer that can be disassembled. One way or another, the entire cleaning process remains very simple and effective with SchleTek's innovative Suppressor Cleaner "Regular".

COMPACT (NON-modular) silencers:

• Seal off the silencer at one end with for example a rubber plug
• Fill the silencer completely with SchleTek Suppressor Cleaner Regular and leave the cleaner act for 120 minutes
• Pour out a small amount of the fluid, then close the silencer at both ends and shake the silencer briefly
• Pour off the rest of the SchleTek cleaner and rinse the silencer with warm water until only clean water starts to flow

silencers that can be taken apart (eg. Modular):

• Place individual parts of the disassembled​ silencer in a container filled with SchleTek Regular cleaner
  • The silencer parts must be completely submerged in the fluid
• After approx. 12 minutes, rinse any loose dirt residue from the silencer components with warm water

aDDITIONAL CLEANING NOTES:

• In the case of extremely resistant dirt residue, repeat the entire process and extend the cleaning time to a maximum of 12 hours
• If necessary, loosen any residual dirt with a fine brush and then rinse the components thoroughly in warm water
• Heating to a temperature of approx. 50 °C increases the cleaning efficiency