Plate Carrier DCS Elite Ops, Warrior, Olive, L, AK/SA58

The Dynamic Combat System DCS by war rior

The shoulders are fully adjustable and have an emergency release on one side which frees the left hand side shoulder section and allows the operator to remove the rig without having to remove his helmet.

The side sections of the DCS are fully adjustable for size and can be adjusted in under 15 seconds. 3D spacer mesh lining is used for comfort and allows body heat to move away from the bodies surface while assisting in air flow to provide cooling.

The DCS was developed to be worn in tandem with the Warrior PLB Belt, Frag Belt and Low Profile Molle Belt (sold separately).

The DCS main plate pockets can hold the following Nexus armour ballistic packages:

• Stand alone plates, 250 mm x 300 mm (10" x 12") and SAPI 238 mm x 314 mm (9.5" x 12.5)
• ICW plates 250 mm x 300 mm and SAPI 238 mm x 314 mm, with Nexus NIJ 3a soft armour

Side Armour Packages

• Stand alone 15 x 15 cm, or 15 x 20 cm side plates.
• ICW plates 15 x 15 cm, or 15 x 20 cm with Nexus NIJ 3a soft armour

NIJ Soft Armour

• NIJ Level 3a soft armour for front, back and sides.

NTOA Certified

Since 2003, NTOA members have tested more than 2,000 products in real world situations through the NTOA’s Member Tested and Recommended Program (MTRP). This product has passed this test and was rated by the NTOA.

Hard Armour

All Warrior lightweight plate carriers are designed to work with Nexus style SAPI shaped 10" x 12" ( 250mm + x 300mm + ) ballistic plates including bevelled edge ceramic plates and smooth edge composite plates. Steel plates with hard edges and corners should be wrapped to protect the internals of the carriers to avoid excessive wear. Warrior Assault Systems will not be held responsible for any damage to a plate carrier from misuse as stated above.

High Quality Threads

Thread quality is fundamental to the construction, durability and strength of tactical equipment.

Two factors have a negative impact on the life Span of threads

1. Mildew is one of the most common factors in the deterioration of military kit, causing it to rot and ultimately results in unacceptable failure.
2. Sunlight has a harmful effect on the performance of threads, and over time causes their deterioration.

Warrior only uses the highest quality US Mil Spec nylon threads imported from the USA which are threated against both UV and Mildew.

• Fiber Resistance to Acid - Good
• Fiber Resistance to Alkali - Good
• Fiber Abrasion Resistance - Excellent
• Fiber Resistance to Heat - 142 deg C (Highest continuous temperature before breakdown)
• Fiber Melting Point - 265 deg C

MIL SPEC Fabric

500D Nylon fabric feature enhanced tear and abrasion resistance, and long lasting durability, 500D Nylon fabric made with solution dyed yarns are inherently stain resistant and easy to clean. MultiCam, Coyote Tan, Ranger Green, Black and A-TACS FG fabrics are all I.R Treated for the lowest signature.

Plastic Hardware

Warrior only uses the highest quality Military rated Clips and accessories.

MOLLE Webbing

This product contains MOLLE webbing that will allow you to attach other pouches using the MOLLE system.

• Genuine US Mil Spec Webbing
• 25 mm (1 Inch) Breaking Strain: 1200 lbs
• 38 mm (1.5 Inch) Breaking Strain: 1800 lbs
• 50 mm (2 Inch) Breaking Strain: 2200 lbs